HP -UX 11i Installation And Update Manual page 135

e. Highlight the PCI 10/100Base-TX or 100Base-FX card and choose
from the
Configure
f. Fill in the form according to the instructions.
g. Click on the
OK
the menu until you exit SAM.
File
3. Verify the installation:
a. Obtain the PPA (on HP-UX 10.20, it is the NMIDnumber) and the
station address of your card by executing:
lanscan
b. To verify that no errors have occurred during installation, enter:
linkloop -i PPA_number station_address
If there is a problem, you can obtain error messages by entering:
dmesg
c. Verify connectivity with a remote system by entering:
ping remote_IP_address netstat -in
d. PCI 10/100Base-TX/9000 or 100Base-FX installation is complete
when you have successfully ran these two commands:
linkloop
ping
e. To configure remote systems, see the Using PCI
10/100Base-TX/9000 guide, available on the Instant Information
CD and on the Web at:
docs.hp.com/
Do this step only if remote systems have not been previously
configured.
Appendix C
Configuring Built-In PCI Networking
Configuring Network Connectivity
menu.
Actions
button to activate the card. Then select from
Exit
135