Booting Workstations - HP -UX 11i Installation And Update Manual

Newer workstation
boot menu
Step 1. Enter: search
Step 2. If the CD device is identified in the list shown by the search command,
Step 3. Enter: boot scsi. x
Step 4. If you see the prompt, Interact with IPL (y or n)?, enter: n
Older workstation
boot menu

Booting Workstations

After stopping the boot process, the system displays a menu:
Command
Auto [boot|search] [on|off]
Boot [pri|alt|scsi.addr] [isl]
alternate or SCSI
Boot lan[.lan_addr] [install] [isl] Boot from LAN
Chassis [on|off]
Diagnostic [on|off]
boot mode
Fastboot [on|off]
flag
Help
Information
LanAddress
Monitor [type]
Path [pri|alt] [lan.id|SCSI.addr]
Pim [hpmc|toc|lpmc]
Search [ipl] [scsi|lan [install]]
devices
Secure [on|off]
mode
When you see the boot menu:
proceed with the following steps. Otherwise, check the device and cable
connections and repeat the search.
Use the SCSI address of the boot device for x .
(The bottom selections may not appear unless you hold down
Older HP 9000 Workstations display a menu similar to this:
b) Boot from specified device
Appendix A
Booting HP 9000 Systems
Booting Workstations
Description
Display or set auto flag
Boot from primary,
Enable chassis codes
Enable/disable diagnostic
Display or set fast boot
Display the command menu
Display system information
Display LAN station addresses
Select monitor type
Change boot path
Display PIM info
Display potential boot
Display or set security
.)
Esc
89