System Requirements - HP -UX 11i Installation And Update Manual

IMPORTANT
Installing
MC/ServiceGuard
On Mission
Critical support?
Migrating to HP-UX 11i
Cold-installing HP-UX 11i
If you have NDS version B.02.00.05 and are updating to HP-UX 11i, be
sure to either select the new version of NDS during the update or remove
the old version from your system. If you run NDS version B.02.00.05
with 11i, the server will cease to work and all client systems may lose the
ability to have anyone log in.
After NDS is installed or updated with HP-UX 11i, additional
configuration steps are required to initiate NDS. See the NDS release
notes available on the HP-UX 11i Instant Information CD for
instructions.
If you are planning to install the HP-UX 11i Mission Critical OE,
MC/ServiceGuard will be automatically installed, removing any previous
version of MC/ServiceGuard on the system. If you will require the
ServiceGuard OPS Edition on the system rather than MC/ServiceGuard,
review "Installing ServiceGuard Products" at the back of this chapter
before continuing. After installing the 11i MC OE, follow the instructions
in that section to replace MC/ServiceGuard with the ServiceGuard OPS
Edition.
If your system is on HP Mission Critical Support, discuss the proper
method of installing and patching the Mission Critical OE with your HP
Customer Engineer.

System Requirements

To cold-install HP-UX 11i, you must have the following:
• A supported HP 9000 server or workstation. Supported systems are
listed in Chapter 1.
• The HP-UX 11i media (2-CD set).
• 64 MB memory, minimum.
• 128 MB swap space, minimum.
• 4GB root volume, minimum, required when installing HP-UX 11i
with or without an operating environment (OE).
40 Chapter 2