HP -UX 11i Installation And Update Manual page 121

Boot Definitions for Volume Group /dev/vg00:
Physical Volumes belonging in Root Volume Group:
/dev/dsk/c0t6d0 (8/0/19/0.6.0) -- Boot Disk
Boot: lvol1
Root: lvol3
Swap: swap
Dump: swap
Step 5. If your changes are correct, reboot the system.
Step 6. After the system reboots, view swap information by entering:
swapinfo
Kb Kb
TYPE
dev
/dev/vg00/swap
reserve
memory
Step 7. To verify that the same configuration exists as before the reboot, enter
(again):
lvlnboot -v
Step 8. As root, use sam to remove the old lvol2 entry from /dev/vg00.
Step 9. Using sam, increase /stand to the required new size. Also change the
size of any other volumes as needed.
Step 10. Define your new volume as the boot volume at the next reboot:
lvlnboot -b lvol1 /dev/vg00
Step 11. Reboot your system again.
Return to Chapter 2 to update your system to HP-UX 11i using the
update-ux command.
Appendix B
on: /dev/dsk/c0t6d0
on: /dev/dsk/c0t6d0
on: /dev/dsk/c0t6d0
on: /dev/dsk/c0t6d0, 0
Kb PCT START/
AVAIL USED FREE
307200 45936 216208
- 113748 -113748
85584 23492 62092
In Case of Trouble
Adjusting File System Sizes
Kb
USED LIMIT RESERVE
0% 0
27%
PRI NAME
- 1
121