HP -UX 11i Installation And Update Manual page 92

Booting a server
Step 1. Switch the system ON.
Step 2. Press any key to stop the autoboot process.
Step 3. Insert the install CD.
Step 4. Determine the hardware path of the install device from your system
Booting HP 9000 Systems
Booting HP 9000 Servers
media
Main Menu: Enter command or menu >
==============================================================
=========
For example, enter: bo p n
where p n is the path number for the install device shown in the search
output. You can also specify the device by the hardware path, such as
56/52.0, in place of the path number.
For Models 8 x 7, 845, 835, 870, and other older HP 9000 Servers, the boot
display looks like this:
==============================================================
Console path
Primary boot path
Alternate boot path = 52.0.0.0.0.0.0
64 MB of memory configured and tested.
Autoboot from primary path enabled.
To override, press any key within 10 seconds.
Boot from primary boot path (Y or N)?> n
Boot from alternate boot path (Y or N)?>
Enter boot path, command, or ?>
==============================================================
administrator. (There is no search capability to determine this
information on older HP 9000 server models).
• If the primary path shown on your screen is not the same as that for
the install device, respond with n to Boot from primary boot path.
In this case, you will then be asked if you want to boot from the
alternate path, which is typically set to the CD device.
• If the primary path shown on your screen matches that for the install
92
= 56.0.0.0.0.0.0
38.0.0.0.0.0.0
= 52.2.0.0.0.0.0
34.00000002.0.0.0.0.0
34.0.0.0.0.0.0
(dec)
(hex)
(dec)
(hex)
(dec)
(hex)
Appendix A