Setting Speed And Duplex Mode At Boot Time (Workstation Only) - HP -UX 11i Installation And Update Manual

Configuring Built-In PCI Networking
Manual Speed and Duplex Mode Configuration
Setting Speed and Duplex Mode at Boot Time
(workstation only)
With this method you may set both the speed and duplex mode of the
interface, and have this setting be in effect across subsequent system
reboots.
To access the LAN configuration commands: From the boot console,
select the and from there select .
Configuration Menu LAN Configuration
From this menu you can configure and display the current mode of
the10/100 Base-T interface using these commands:
LanConfig Display current configuration settings.
Operate in 10 Mbit/s, half-duplex mode.
LanConfig 10/Half_dx
LanConfig 100/Half_dx Operate in 100 Mbit/s, half-duplex mode.
Operate in 10 Mbit/s, full-duplex mode.
LanConfig 10/Full_dx
LanConfig 100/Full_dx Operate in 100 Mbit/s, full-duplex mode.
LanConfig AUTO_detect (default) Enable auto-negotiation.
If you don't use this method, the system boots up with the default setting
AUTO_Detect.
138 Appendix C