Mounting; Parallelism; Gasket Position - Tecfluid FLOMID Series Instruction Manual

5

MOUNTING

5.1

Parallelism

The maximum parallelism error must be less than 0.5 mm (Lmax—Lmin ≤ 0.5 mm).
5.2

Gasket position

In the wafer sensors, to avoid leakage of liquid inside the sensor, it must be ensured that the
rubber gasket (A) of the figure is well centered, so that it presses directly on the plastic of the
sensor.
The standard material of the supplied gasket is NBR. Other materials can be supplied on
demand.
The sensors for connection other than wafer, are supplied without gaskets.
12