Table of Contents
Advertisement
Progress bar will indicate the process, after which the message "Device programmed" will
appear.
From this moment, the MBC1 converter already has the new version of Firmware.
12.10 Configuration file
A device configuration backup can be made by saving data into a file. To do this, go to menu
"File" - "Save file".
The file is saved in the same folder where the Winsmeter MBC1 software is located.
In the same way, a configuration data file can be loaded into the device. To do this, go to the
menu "File" - "Load file", and the file explorer will appear. The file has to be searched there.
The filename is the serial number and the extension is INI.
NOTE: When the configuration is saved into a file, the stored data are those in the device
memory. These data may be different from those shown on the Winsmeter program. To ensure
that the data match press the "Send" button in the "Programming" tab.
IMPORTANT: The USB connection is used only for the configuration and commissioning of
the device. In no case it is intended to be used continuously, as a normal mode of operation
in an industrial environment.
12.11 Default values
From the menu "Firmware", if the "Installation" window is enabled, the submenu "Default
values" can be accessed. It is useful to return the instrument to factory values.
47
Advertisement
Table of Contents
