Table of Contents
Advertisement
1
INTRODUCTION
The MBC1 converter unit can be used with the different FLOMID and FLOMAT series of
electromagnetic flow sensors. The electronic circuit is based on the most advanced
technology in digital signal processing, in order to obtain accurate and reliable
measurements.
This converter is completely autonomous since it can work with batteries. If desired, it can
also work with an external power supply that allows to have digital outputs and Modbus
communication.
The device provides the following features:
Coil excitation by means of pulsed signal to obtain a negligible zero offset.
-
Empty pipe detection.
-
Digital outputs programmable as pulses proportional to flow rate or as flow rate or
-
status alarms (only with external power supply).
SD card with programmable activity register (datalogger).
-
Easy exchange with other sensors.
-
Graphic display with intuitive menus.
-
Adjustable front cover in order to make display reading easier, depending on
-
installation.
Modbus RTU communication (only with external power supply).
-
2
INSTALLATION
2.1
Sensor connection
The converter provides two cables to be connected to the sensor. Once connected, slide
the converter along the sensor neck until the stop. Tight the two fixing screws.
MBC1 CONVERTER
15
Advertisement
Table of Contents
