Chapter 3 - Installing The Devices; Assemble The Modular Panel Pc - DFI KS-SD Series User Manual

Chapter 3 - Installing the Devices

Assemble the Modular Panel PC

The modular panel PC comprises two parts: a box module and a panel module. The assembly of
these two parts is easy thanks to DFI's ADP (Adaptive Display Platform) innovation, which makes
the box modules and the panel modules interchangeable. Please use the following procedure to
assemble these two parts.
1. Take off the cover of the ADP connector.
ADP
connector
cover screw
Box Module
User's Manual | KS-SD
2. Hold the box module with its ADP connector (female) in line with the ADP connector (male)
of the panel module. Align the box module with the panel module using the alignment posts.
Alignment
Post
ADP
Connector
(female)
Note:
If the orientation of the assembly is not correct, the box module will not seat evenly
on top of the panel module, which results in some space in between them and
indicates that the ADP connectors are not engaged. When this is the case, please turn
the box module the other way around.
3. Place the box module on top of the panel module with the alignment posts effortlessly slip-
ing into the designated holes on the box module. Press to install these two modules and
secure the installation with 8 mounting screws.
Panel Module
Mounting Screw
Alignment
Post
Mounting Screw
Box + Panel Module
Chapter 3
11