Table of Contents
Advertisement
Panel Mount
The panel mounting kit includes the following:
•
10 mounting clamps
1.
Select a place on the panel (or wall) where you will mount the Panel PC.
2.
Cut out a shape on the panel that corresponds to the Panel PC's rear dimensions (15":
367mm x 300mm; 18.5": 454mm x 296mm; 19": 447mm x 380mm; 21.5": 526.2mm x
342.6mm) and ensure that the Panel PC can be fitted into the panel properly.
Mounting hole
Panel
3.
Insert the Panel PC from the outside surface of the panel into the mounting hole until it is
properly fitted against the panel.
4.
Position the mounting clamps along the rear edges of the Panel PC and insert them into the
slits around the Panel PC. Note that the following diagram is for illustration only and may not
resemble the actual product.
User's Manual | KS-SD
Y
X
cap
Mounting clamp
5
Slit for mounting the clamp
5.
The first and second clamps must be positioned and secured diagonally prior to mounting
the rest of the clamps. Tighten the clamp's screw using an electric screwdriver by pressing
the flat cap onto the back of the panel.
210.50
Note:
The maximum thickness of your panel's mounting wall should be 10 mm for secure
panel mount.
Chapter 6
31
Advertisement
Table of Contents
