Table of Contents
Advertisement
Chapter 3 - Installing Devices
Removing the Chassis Cover
Please observe the following guidelines and follow the procedure to open the system.
1.
Make sure the system and all other peripheral devices connected to it have been powered
off.
2.
Disconnect all power cords and cables.
3.
The 4 mounting screws attached touchscreen cover and the 6 screws on the sides of the
system are used to secure the touch panel to the chassis. Remove these screws and put
them in a safe place for later use. Be careful when opening the touch panel to avoid pulling
the connecting cables apart.
4.
Lift the cover to open the system. The Mini PCIe socket is readily accessible after removing
the top cover.
Chapter 3 Installing Devices
Chapter 3
Installing a Mini PCIe Card
The system board is equipped with 1 full-size Mini PCIe slot that supports both PCIe and USB signals.
1.
Grasp the Mini PCIe card by its edges and align the notch of the card with the key in the
connector on the system board.
Mounting screw
2.
Push down on the other end of the Mini PCIe card and use the provided mounting screw to
secure the card on the system board.
Mounting screw
Antenna hole
Mounting screw
Note:
If installing a wireless module, place the antenna cable(s) on top of the Mini PCIe and
route the cables to the side of the chassis to reach the antenna holes.
11
Mini PCIe socket
Mounting screw
www.dfi.com
Advertisement
Table of Contents
