Device Manager - DFI KS-SD Series User Manual

Device Manager

This Device Manager menu is used to configure UEFI network settings when the "Network
Stack" is enabled in the "Dual" or "UEFI" boot mode or when the PXE Boot to LAN is enabled
in the "Legacy" boot mode. Refer to the "Boot" section in this chapter. When this function is
selected, the screen will warn you that you are going to exit the BIOS setup utility.
User's Manual | KS-SD
Network Device List
The "Device Manager" screen is displayed. And if the "Network Stack" or the "PXE Boot to LAN"
option is enabled from the "Boot" menu, the "Network Device List" should be shown in the "Device
list". Select "Network Device List" to view all of the detected network devices. For each network
device, you can select to view and configure its settings. In addition, you can select either the
IPv4 or IPv6 network settings for UEFI network configuration.
Port Configuration Menu
This screen shows hardware information for the Ethernet controllers and configures their operation.
Blink LEDs
Enter the duration (seconds) for the Ethernet's speed LED to blink to indicate its presence.
Chapter 7
39