Page 1
• 1 DVD disk includes: - Manual DFI reserves the right to change the specifications at any time prior to the product's release. For the latest revision and more details of the installation procedure, please refer to the user's manual on the website.
Page 2
Panel COM 2 (RS232/RS422/RS485) Top View Antenna Hole COM 1 (RS232/RS422/RS485) USB 3.0 DP++ DC-in Power on/off Mic-in Bottom View Line-out LAN 2 LAN 1 USB 2.0...
Installing a CFast Card The CFast card slot can be accessed externally without opening the chassis. Before installing a CFast card, take off the CFast card slot cover. CFast slot cover 1. Gently insert the CFast card straight with the label on the CFast card facing up until you feel it lock into place.
Removing the Chassis Cover 1. Make sure the system and all other peripheral devices connected to it have been powered-off. 2. Disconnect all power cords and cables. 3. The 12 mounting screws on the top and bottom as well as both sides of the system are used to secure the cover to the chassis.
Installing an M.2 Card The system is equipped with one M.2 socket, supporting the M.2 22x42mm (key B) form factor. Use the following procedure to install an M.2 card: 1. Align the notch at the edge of the M.2 card with the key in the connector. 2.
Installing a Mini PCIe Card The system board is equipped with one Mini PCIe slot that supports PCIe and USB signals. Use the following procedure to install a Mini PCIe card: 1. Grasp the Mini PCIe card by its edges and align the notch in the connector of the PCIe card with the key in the connector on the system board.
Mounting Options VESA mount The VESA mount kit includes the following: • 2 VESA mount brackets • Bracket screws VESA mount bracket 1 VESA mount bracket 2 1. Before starting any installation procedures, attach the poron foam to the Panel PC. Poron foam 2.
Page 8
4. Attach the other bracket (VESA mount bracket 2) to the rear of the Panel PC. Mounting screw VESA mount bracket 2 Hooks 5. Slide the Panel PC to "VESA mount bracket 1" to attach the two brackets with the hooks. Then tighten the screw to secure the assembly in place. Screw...
Page 9
Panel mount The panel mounting kit includes the following: • 6 mounting clamps 1. Before starting any installation procedures, attach the poron foam to the Panel PC. Poron foam 2. Select a place on the panel (or wall) where you will mount the Panel PC. 3.
Page 10
6. The first and second clamps must be positioned and secured diagonally prior to mounting the rest of the clamps. Tighten the clamp’s screw using an electric screwdriver by pressing the white plastic cap onto the back of the panel. The illustration below shows that all clamps are properly mounted.
Board Layout and Jumper Settings SPK-OUT EIO (optional) DC-in DC-in Digital I/O SMBus Front Audio Intel WGI211AT LAN 1 (JP1) (JP11) 9 10 Intel USB 2.0 WGI211AT (JP10) LAN 2 USB 5-6 M.2 Signal Select (JP1) USB 1/4 USB 3.0 LCD/Inverter LCD/Inverter Power Select (JP11)