Using A Pointing Device With A Touch Screen; Calibrating The Touch Screen; Installing The System Into A Panel - Xycom 9462 System Manual

9460/9460KP/9462/9462KP System Manual
4. Reconfigure Jumpers J1-J5. Position A = COM2. Position B = PS/2 mouse.
5. Reinstall the touch screen controller card.
6. Reboot the computer.
7. Using the touch screen manual do the following:
•
•
•
8. Replace the lid.

Using a Pointing Device with a Touch Screen

The touch screen setup program needs to know if you are using another pointing device
with the touch screen. The Windows touch screen driver does not display the cursor. In-
stead, the pointing device driver is responsible for displaying the cursor.
In the touch screen setup program, Support for Another Pointing Device, select the fol-
lowing:
If you are
using a mouse with
the touch screen
not using a mouse

Calibrating the Touch Screen

If you need to recalibrate the touch screen, refer to the sections in the touch screen man-
ual that explain calibration and using the diagnostic utility.
You need to calibrate the touch screen if
•
The cursor does not follow the movement of your finger or pen.
•
You adjust the size of the video image or change the video mode.
The touch screen and controller are a matched pair calibrated at the fac-
tory.

Installing the System into a Panel

The system's rugged design allows it to be installed in most industrial environments. The
system is generally placed in a NEMA 4/4X/12 enclosure to protect against contaminants
such as dust, moisture, etc. Metal enclosures also help minimize the effects of electro-
magnetic radiation that nearby equipment can generate.
3-22
Load the touch screen drivers.
Reconfigure the touch screen driver for COM2.
Recalibrate the touch screen.
Select Result
Yes The pointing device driver controls the cursor display
No The Setup program loads a cursor display driver
(MTSMOUSE.DRV) as well as the Windows touch screen driver
Note