Running The Tests - Xycom 9462 System Manual

Running the Tests

To run the test, insert the diagnostics disk into drive A. Turn on the computer (the dia g-
nostics program will boot-up). Figure 2- 2 shows the Main Menu.
1. WILL pause on error
2. SINGLE PASS test mode
3. Save setup to file
4. Extract setup from a file
A) RAM Test
B) Video RAM Test
C) Extended RAM Test
D) Real Time Clock Test
E) COM1 Serial Port Test
F) COM2 Serial Port Test
G) COM3 Serial Port Test
H) COM4 Serial Port Test
I) Math Coprocessor Test
J) Video Adjustments Test
Use the letters to move the cursor and select/deselect, or use the arrow keys to
move, then use the [SPACE] key to select/deselect a test or function.
Please read the DIAG.TXT file on the diagnostics disk for detailed in-
formation about the tests.
Avoid repeated running of any hard disk diagnostic utility, if you use the
Solid State (Flash) drive option. The Flash drive has a limited number of
writes to each logical sector. Repeated writes from a diagnostic utility will
prematurely shorten the life of the drive.
Copyright 1990-1996, Xycom, Inc. All rights reserved.
Diagnostic Tests Sequence/Selection Menu (Rel. xx)
5. Auto-select tests
6. Deselect all tests
7. Quit and exit to DOS
8. Return to previous screen
K)
L)
M)
N)
O)
P)
Q)
R)
S)
[ENTER]=START TESTING
Figure 2- 2. Main Menu
Note
Note
Video Interface Test
Speaker Port Test
LPT1: Printer Port Test
LPT2: Printer Port Test
C: Hard Drive Interface Test
D: Hard Drive Interface Test
A: Floppy Drive Interface Test
B: Floppy Drive Interface Test
Keyboard, Keypad Tests
≡
= Test Selected
Chapter 2 – Testing
2-3