Miscellaneous Drivers; Using A Touch Screen - Xycom 9462 System Manual

Miscellaneous Drivers

Refer to your operating system and peripheral manuals for information on installing
drivers related to these items.
If Windows NT is installed on your system, you may have to purchase
and install an external parallel port CD-ROM drive to install Windows
NT drivers. The Windows NT operating system only ships on CD-ROM.

Using a Touch Screen

Xycom's touch screen complies with environmental specifications and maintains a
NEMA 4 seal when panel mounted. It remains operational even after 30 million touches.
The touch screen Monitor Mouse driver emulates a Microsoft mouse.
If MS-DOS, Windows 3.x, or Windows 95 is installed on your system,
the touch screen is configured for the mouse port and the mouse port is
unavailable.
If Windows NT is installed on your system, the touch screen is set up on
COM2 and the COM2 port is unavailable for other use.
To reconfigure the touch screen to use the COM2 port, perform the following steps:
1. Disconnect the power.
2. Remove the lid.
3. Remove the touch screen controller card. Figure Chapter 3 -15 shows the touch
screen controller card and the jumper set.
Note
Note
Figure Chapter 3 -15. Touch screen controller card.
Chapter 3 – Installation
3-21