Preparing The System; Installing Internal Hardware Options; Dram And Additional Dram Single In-Line Memory Modules (Simms) - Xycom 9462 System Manual

9460/9460KP/9462/9462KP System Manual

Preparing the System

Read this chapter first, comply with all the safety requirements, then mount the unit ac-
cording to the following instructions.
1. Locate a position that meets the required specifications
2. Do a panel cutout. The dimensions are given in this chapter.
3. Install optional equipment following the instructions in Installing Internal Hardware
Options and Installing External Hardware Options in this chapter.
4. Create the power cable. Refer to the Creating a Power Cable section later in this
chapter.
5. Mount the system and properly secure the unit into the panel. See Installing the Sys-
tem section later in this chapter.
6. Attach one end of the power cord to the power receptacle and the other end to a
properly grounded 115/230 VAC, 50-60 Hz outlet or a 24 VDC outlet, whichever
applies (refer to the Hazardous Location Installations section later in this chapter).
7. Turn on power to the system. The system will boot up to the operating system in-
stalled.
8. Install the application software via a floppy drive.
If a touch screen has been factory installed along with MS-DOS, the mouse port is un-
available. The unit will arrive with a sticker placed over the port. If you would like to re-
configure the touch screen to use the COM2 port, follow the instructions in the Using a
Touch screen section later in this chapter.

Installing Internal Hardware Options

Remove the lid to install internal hardware options.

DRAM and Additional DRAM Single In-line Memory Modules (SIMMs)

You can order your system CPU factory-configured for many configurations of DRAM.
You can reconfigure the DRAM capacity by changing the DRAM SIMMs on your board.
For more information, refer to the CPU manual.
3-8
Caution
Turn off the unit before installing internal hardware.