Table of Contents
Advertisement
PC/AT and PCI Boards
1. Check that the memory and I/O configuration of the board you want to install does
not conflict with the CPU and I/O memory maps in your CPU board manual.
2. Remove the lid.
3. Remove the ORB screw in the desired track.
4. Slide the PC/AT expansion board into a corresponding rail.
5. Push the board into the backplane connectors.
6. Secure the board by installing the screw through the hole in the board's metal ORB
and into the top of the track.
7. Replace the lid.
Installing External Hardware Options
This section explains how to install the external hardware options available with the
system.
When using the external floppy drive, do NOT attach the drive with a
diskette installed. You may corrupt the disk.
External Floppy
The external floppy (9000-EXF) can be mounted on the back of the unit. There are four
screw holes on the back of the unit for the floppy mounting. A fifth screw hole is on the
back for the cable clamp screw. See the figures of the back panel and the bottom panel
(Figures 3-3 and 3-4).
Front mounting options are also available.
Make sure the floppy drive cable will reach the external floppy connec-
tor on the system before making the cutout.
Note
Do not force the boards or apply uneven pressure.
Note
Note
Chapter 3 – Installation
3-9
Hide quick links:
Advertisement
Table of Contents
