Control Set; Control Set Detail - GRAUPNER mz-32 HoTT Reference Manual

Graupner mz-32 Help Reference Manual
Limit: sets the maximal servo deflection to a value where the servo does not mechanically
bind.
B04S2
A control for a channel can be set globally or phase dependent allowing you to change the
control used depending on the flight phase.
To assign a control to a channel, tap on the channel control field. Moving a control will
automatically record that control as the main control. You can have different input control
types assigned to each channel.
Additional control types can be created in the special menu.
The values in the delay fields will determine the speed of the control movement.
Tapping on the detail icon provides access to different curve types to fine tune your channel
behavior.
B06S1
(linear, flat and multi point). Tap on the curve type icon to change the curve type. You can
select the spline type by tapping on the spline icon.
In the value menu you can set the curve (travel) behavior of the channel.
Depending on the curve type selected you can move the curve over the Y axis or X axis
and change each curve point or offset.
To change a curve point, move the control to select the point so that it becomes active.
You can make changes by tapping on the X and Y fields arrow keys or you can slide the
colored tabs along the X and Y axes.
Adding or removing curve points can be done by moving the control over the curve point
and, when highlighted, tapping the minus key for delete, or by positioning the control cursor
over a point along the curve and tapping the plus key for adding a point.

CONTROL SET

In the Control Set menu, you can set the controls such
as switches, sliders and buttons that will activate and
operate each channel. When setting up your model, the
system automatically assigns controls depending on
your model setup. It is not recommended changing
these pre-set controls.
Scrolling the control set menu down (swipe the screen
up or down) will show the first 16 available channels.
To view channels 17 – 32 tap on the page icon next to
the question mark.
To change the channel name, tap on the channel
number or channel name which reveals the edit bar.

CONTROL SET DETAIL

The Control Set detail menu provides various curve
types that can influence servo travel as well as channel
offsets.
The basic menu displays the active channel and
whether the channel is global or phase dependent. The
overlay channel field provides access to a field selection
menu where you can pick another channel to overlay
the existing channel. If the channel curves are
different, a brown graph line will show the differences
between each channel. This can be helpful when trying
to create identical curves between multiple channels.
In the other menu, you can select the curve type
Page 10 of 42 Help-Ref-EN-V1.0