Table of Contents
Advertisement
Maintenance
Performing operational maintenance
9.4.3.2
Recommended cleaning agents
Flat surfaces and
cavities
For deposits that
adhere to finished
surfaces
Shafts and rollers
9.4.3.3
Cleaning the machine
Prerequisites
Cleaning the
machine
132
CAUTION!
Used cleaning cloths.
Non-observance could result in injury or property damage.
•
Observe fire hazards resulting from the inflammability of the cleans-
ing agent.
•
Dispose of the cleaning rags in an environmentally-friendly fashion.
•
Inform yourself by asking the cleaning agent manufacturer about
residual risks and about environmentally friendly disposal.
Suction clean or sweep out
(No compressed air as there is a risk of bearing damage)
Solvent-free cleansing agent
MBO Binder GmbH & Co. KG recommends "Varn" cleansing agent with the
designation: "VM 111 or VWM Wash".
The "Varn" company delivers to the printing industry worldwide.
Therefore, it cannot be excluded that in certain other countries different
designations are used.
Therefore, please use the respective order no. from the technical data
sheets of the "Varn" company.
Be sure to follow the manufacturer's safety instructions.
Proceed as follows to clean the machine.
These prerequisites must be fulfilled:
• Main switch is switched off and secured.
• EMERGENCY STOP palm button is pressed.
• Clean the machine at least once per week.
• The dust layer must never exceed 1 mm (0.039 in.).
• Especially clean dirt (paper dust, printing powder, etc.) from moving
parts.
Here's how to clean the machine:
Suck up the dirt.
Use a brush for hard-to-reach areas.
Wipe down the surfaces using a dry cloth.
Do not use any aggressive chemical detergents or cleaning agents.
The machine is clean.
Rewinder RW500
Advertisement
Table of Contents
