Table of Contents
Advertisement
8.3.2
Insert the core shaft with empty sleeve
Prerequisites
Inserting the
core shaft
Rewinder RW500
Proceed as follows to insert a core shaft with empty sleeve.
These prerequisites must be fulfilled:
• A full paper roll has been removed.
WARNING!
Clamping the core shaft in loaded status.
Non-observance could result in serious injury or death.
•
It is only permitted to clamp or vent the core shaft in unloaded status,
i.e. the paper roll must be on the ground.
•
The press bars in the core shaft are otherwise positioned unevenly
on the roll core and there is a dangerous imbalance.
4
1 Compressed air pistol with
pressure gage
2 Compressed air valve
Illustration 58: Inserting the core shaft
Here's how to insert the core shaft:
Vent the core shaft on the compressed air valve (2).
Slide an empty sleeve (4) over the core shaft (3).
Fit the core shaft (3) into the roll lift.
Position the empty sleeve (4) on the center of the core shaft (3).
Fit the compressed air pistol (1) onto the compressed air valve (3).
Actuate the compressed air pistol (1) until the maximum pressure has
been built up (6 bar).
Only remove the compressed air pistol (1) from the compressed air
valve (2) when activated. Otherwise the core shaft would be vented
again.
The core shaft has been inserted.
Adjustment and operation
2
3
3 Core shaft
4 Empty sleeve
Adjustment
1
113
Advertisement
Table of Contents
