Table of Contents
Advertisement
Adjustment and operation
Operation
8.2.3
Switching on <Setup / production> operating modes
Prerequisites
Switch on
<Setup>
operating mode
Switch on
<Production>
operating mode
102
Proceed as follows to switch on the operating modes.
These prerequisites must be fulfilled:
• The main switch is switched on.
• The machine is stationary.
• The movable guards are closed.
Illustration 49: Change over the operating modes
Here's how to switch on the <Setup> operating mode:
Press the <Setup / production operating mode> (1) for approx. 3 sec-
onds.
The illuminated button (1) is lit yellow.
The <Setup> operating mode is switched on.
The following functions are active in the <Setup> operating mode:
•
Lower roll lift
•
Raise roll lift
•
Open/close brake
•
Set the position of the pneumatic dancer
•
Set the position of the weight force dancer
•
Inch the in-feed shaft
•
Raise/lower pressure arm
•
Change the rewind direction of the paper roll
Here's how to switch on the <Production> operating mode:
Press the <Setup / production operating mode> illuminated push but-
ton (1) for approx. 3 seconds.
The illuminated button (1) is lit green.
The <Production> operating mode is switched on.
The following functions are automatically moved to the <Production> po-
sition after switching to the <Production> operating mode (3):
•
Weight force dancer
•
Pneumatic dancer
•
Pressure arm.
1
Rewinder RW500
Advertisement
Table of Contents
