Table of Contents
Advertisement
Adjustment and operation
Adjustment
8.3.3
Feeding in the web
Prerequisites
114
Proceed as follows to feed in the web.
These prerequisites must be fulfilled:
• The <Setup> operating mode is switched on.
• A core shaft with empty sleeve is located in the roll lift.
• The paper roll brake is switched off.
• The nip roller on the in-feed shaft is open.
• The weight force dancer is in the <Setup> (top) position.
• The pneumatic dancer is in the <Setup> (top) position.
.
WARNING!
Crushing and drawn-in hazard.
Non-observance could result in serious injury or death.
•
Only feed in the web when the system is at a standstill.
1
2
3
1 Paper roll
2 Pressure shaft
3 Guide shaft
4 Guide shaft
5 Web
6 Guide shafts
7 in-feed shaft
Illustration 59: Feeding in the web
5
6
4
7
8
14
8 Nip roller
9 Guide shafts
10 Guide shaft
11 Infeed shaft
12 Movable dancer shaft
13 Guide shaft
14 Movable dancer shafts
9
10
13
12
11
Rewinder RW500
Advertisement
Table of Contents
