Table of Contents
Advertisement
Adjustment and operation
Adjustment
8.3
Adjustment
8.3.1
Brief instructions for adjusting the machine
112
The machine is adjusted in these work steps.
1)
Operate the machine.
See chapter "8.2 Operation".
2)
Switching on setup mode.
See chapter "8.2.3 Switching on <Setup / production> operating
modes".
3)
Set the pneumatic dancer to the <Setup> position.
See chapter "8.2.7 Pneumatic dancer, set position".
4)
Set the weight force dancer to the <Setup> position.
See chapter "8.2.8 Weight force dancer, set position".
5)
Switching off the paper roll brake.
See chapter "8.2.5 Switching off/on the paper roll brake".
6)
Insert the core shaft with empty sleeve.
See chapter "8.3.2 Insert the core shaft with empty sleeve".
7)
Set the rewinding direction.
See chapter "8.2.6 Adjusting the rewind direction of the paper roll"
8)
Feed in the web.
See chapter "8.3.3 Feeding in the web".
9)
Close the nip roller.
See chapter "8.3.3 Feeding in the web"
10) Connecting the web after a roll change.
See chapter " ".
11) Switching on the paper roll brake.
See chapter "8.2.5 Switching off/on the paper roll brake".
12) Set the pneumatic dancer to the <Production> position.
See chapter "8.2.7 Pneumatic dancer, set position".
13) Set the weight force dancer to the <Production> position.
See chapter "8.2.7 Pneumatic dancer, set position".
14) Switching on production mode.
See chapter "8.2.3 Switching on <Setup / production> operating
modes".
15) Setting the internal web tension.
See chapter "8.3.5 Setting the internal web tension".
16) <Set the full paper roll> position.
See chapter "8.4 Set <Full paper roll>".
17) Troubleshooting.
See chapter "8.6 Identification and handling of malfunctions".
The machine has been adjusted.
Rewinder RW500
Advertisement
Table of Contents
