Table of Contents
Advertisement
8.2.11
Creating production readiness
Prerequisites
Illustration 57: Creating production readiness
Rewinder RW500
Proceed as follows to create production readiness.
These prerequisites must be fulfilled:
• The <Setup> operating mode is switched on.
1
2
8
Here's how to get ready for production:
1)
Fit the rewinder with a core shaft and an empty sleeve.
2)
Set the correct rewinding direction.
3)
Guide the web through the rewinder to the core shaft.
4)
Affix the web to the empty sleeve.
5)
Switch the paper roll brake (4) on.
6)
Lower the pressure arm (5).
7)
Set the weight force dancer to the <Production> position (6).
8)
Set the pneumatic dancer to the <Production> position (3).
9)
Close the nip roller of the in-feed shaft.
10) Switch the web guide on (option).
11) Switch the <Production> operating mode (2) on.
The illuminated button (2) is lit green.
The <Reset emergency stop> illuminated button (1) does not light up.
The <Stop request> illuminated button (8) lights up in red.
The system is ready for production.
Adjustment and operation
3
7
6
5
4
Operation
111
Advertisement
Table of Contents
