Minolta CA-100Plus Instruction Manual page 82

<For Analyzer Mode>
If analyzer measurement mode is selected, measurement results will be displayed as shown below.
Digital display section
• Display contents : R, B, G
• Display range
Analog display section
• Display contents : When analyzer mode (G-standard) is selected
* For details on the analog display function and how to set the range for each dot, refer to page 69.
When the analog display range is set to n%
Red
-n×8% or
lower
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Outputs of the currently
measured monochrome
lights R, B and G in ratio
(%) to those of the specified
target color (W)
: When measured values are displayed in 4 digits
0.01 to 99900%
In 0.01 step for the range from 0.01 to 99.99%
In 0.1 step for the range from 100.0 to 999.9%
In 1 step for the range from 1000 to 9999%
In 10 step for the range from 10000 to 99990%
When measured values are displayed in 3 digits
0.01 to 99900%
In 0.01 step for the range from 0.01 to 9.99%
In 0.1 step for the range from 10.0 to 99.9%
In 1 step for the range from 100 to 999%
In 10 step for the range from 1000 to 9,990%
In 100 step for the range from 10000 to 99990%
R/G, B/G: Ratio of measured values
∆G: Difference from the target color in the case of mono-
chrome light G
When analyzer mode (R-standard) is selected
∆R: Difference from the target color in the case of mono-
chrome light R
G/R, B/R: Ratio of measured values
Green
Red
+n×8% or
Below ±n%
higher
Below ±n×2%
Below ±n×4%
Below ±n×8%
R
B
G
79
R/G
B/G
∆G
R/G
B/G
∆G
∆R
R/G
B/R B/G
∆G
G/R