Table of Contents
Advertisement
5 REMOTE key ....................................... • Sets the instrument in remote mode (i.e. communication with the
6 MEMORY CH
<Keys on Key Panel>
1 Number-key (
~
2 ALPHA key (
) ................................... • Used to enter alphabets. This key enables you to use the number-
3 Alphabet keys (
~
4 MENU key (
) ..................................... • Switches the LCD display section to the menu selection screen.
5 CAL key (
) ........................................ Normal Screen
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
PC is possible via RS-232C or USB).
(The REMOTE LED will light up. See page 86.)
• Pressing this key while the REMOTE key is lit will cancel remote
mode. (The lamp will go out.)
(Note) Remote mode should not be activated unless you are going to communi-
key ........................ • Used to select a memory channel (CH00 to 99).
key
Pressing the
"00→01→02 ...
Pressing the
"00→99→98 ...
The memory channel switches from one to another each time the
key is pressed, and switches continuously if the key is left held
down.
,
) .................. • Used to enter calibration data for user calibration (page 51), target
color (page 62), ID name (page 67) and analog display range (page
69).
key as alphabet keys. Pressing this key again will restore the origi-
nal function of the ten-key.
,
) ................ • Used to enter alphabets for the ID name.
Pressing this key again will restore the original function of the LCD
display section.
• When CH00 is selected as the memory channel
You can enter a value for the target color. (Page 65)
• When thememory channel other than CH00 is selected as the memory
channel
You can set CA-100 for input of WRGBdata for user calibration.
(Page 51)
• When an analyzer measurement mode is selected
You can set CA-100 for input of RGB emission characteristic and
target color (W). (Page 59)
Menu Selection Screen
• Pressing the
to switch as follows.
PROBE selection → SYNC selection → ID Name input → RANGE
setting → Measurement Speed selection → Number of Digits set-
ting → Calibration Standard selection → RS232C Baud Rate se-
lection → PROBE selection
This does not apply in the case of flicker mode.
cate with the PC.
Otherwise, the other keys will be inoperative.
key will switch memory channel in the order
98→99→00 ... ".
key will switch memory channel in the order
01→00→99 ... ".
key in the menu selection screen causes the screen
17
Advertisement
Table of Contents
