Table of Contents
Advertisement
4. Selecting the Number of Display Digits
The number of display digits can be selected from 4 or 3.
However, T is always displayed in three digits, and flicker is always displayed up to the first decimal place.
[Selecting Method]
1
.
Press the
key.
The LCD display will switch to the menu selection
screen.
2
.
Press the
key to open the number of
display digits selection screen.
Each time the
key is pressed, the screen will switch
in the order PROBE → SYNC → ID Name input →
RANGE → Measurement Speed → Number of Digits
→ Calibration Standard → RS232C Baud Rate →
PROBE.
3
.
Press the
key until the desired number
of display digits appears.
Each time the
play digits switches alternately between "4 FIGURES"
and "3 FIGURES".
4
.
Press the
key to confirm the selection.
* By default (factory setting), the instrument is set so that "4 FIGURES"
will be selected automatically when the POWER switch is set to ON. If
you want to change this setting, refer to page 29.
* To cancel selection of the number of display digits, press
<Notes on Number of Display Digits Setting>
The selected number of display digits will be kept even if the POWER switch is set to OFF. The selected
number of display digits will be effective when the POWER switch is set to ON.
If the instrument is used in CA-100 compatible mode, the number of decimal places displayed will vary with
the number of display digits set here. Normally, set the number of display digits to 4. (Refer to page 15.)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
key is pressed, the number of dis-
PQRS
TUV
7
8
GHI
JKL
4
5
White
ABC
1
2
Red
Green
0
.
Menu selection screen
MENU : SELECT
PUSH SPACE KEY
Number of display digits
selection screen
SELECT : DISP.
4 FIGURES
SELECT : DISP.
3 FIGURES
key.
42
42
WXYZ
1
9
MENU
MNO
LOCK
6
ALPHA
DEF
- SPACE
2
3
CAL
3
Blue
4
ENTER
Press the
the desired number of
display digits appears.
key until
Advertisement
Table of Contents
