Table of Contents
Advertisement
In this example, "EXT D-1.50" is set as the ID name.
1 Press the
key.
2 Press the
key twice.
"E" will appear at the cursor position.
3 Press the
key twice.
"X" will appear at the cursor position.
4 Press the
key once.
"T" will appear at the cursor position.
5 Press the
key twice.
" " will appear at the cursor position.
6 Press the
key once.
"D" will appear at the cursor position.
7 Press the
key once.
"-" will appear at the cursor position.
8 Press the
key.
9 Press the
key.
"1" will appear at the cursor position.
0 Press the
,
".", "5" and then "0" will appear at the cursor position.
5
.
Press the
key.
The ID name will be set for the selected memory channel.
* To cancel ID name setting, press the
<Notes when Setting an ID Name>
The ID name will be kept even if the POWER switch is set to OFF.
Never press the following keys during ID name setting.
Doing so will cancel setting and activate the mode corresponding to the pressed key.
( 0-CAL , MODE , REMOTE , MR , MEMORY CH
If the
key is pressed while the
for setting the analog display range will appear.
When the optional 4-point expansion board CA-B04 is used
Only one ID name can be set for each memory channel irrespective of the number of probes connected. (The
specified ID name will be common to all probes [P1] to [P5].)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
and then
key.
key.
key is not held down (i.e. the ten-key is not used as alphabet key), a screen
)
,
68
CH01 EXT
Ad P1
[E
]
_
CH01 EXT
Ad P1
[EX
]
_
CH01 EXT
Ad P1
[EXT
]
_
CH01 EXT
Ad P1
[EXT
]
_
CH01 EXT
Ad P1
[EXT D
]
_
CH01 EXT
Ad P1
[EXT D-
]
_
CH01 EXT
Ad P1
[EXT D-1
]
_
CH01 EXT
Ad P1
[EXT D-1.50]
_
Advertisement
Table of Contents
