Table of Contents
Advertisement
About CA-100 Compatible Mode
This instrument offers two modes: "CA-100 compatible mode", that provides data compatibility with measured
data taken by the CRT color analyzer CA-100 and allows communications via RS-232C, and "CA-200" mode, that
allows use of the CA-SDK software supplied with this instrument. "CA-100 compatible mode" has been set prior
to shipment from the factory.
If you already have a CA-100 unit and need data compatibility with it or if you have established a CA-100-based
communication environment and are going to introduce this instrument, use "CA-100 compatible mode".
<CA-100 Compatible Mode>
Number of display digits: Fixed at 3 digits (cannot be changed)
The number of decimal places displayed in CA-100 compatible mode varies with the selected number of dis-
play digits (3 or 4) for CA-200 mode.
When 3 is set: Displayed in up to the first decimal
place.
When 4 is set: Displayed in up to the second decimal
place.
* Normally, the number of display digits must be set to 3 to display up to
the second decimal point.
For a description of the setting method, refer to page 42.
Allows control of the instrument using RS-232C commands
(same as CA-100).
[Setting Method]
Once a mode is selected by this method, it will remain effective until it is changed by this method.
1
. Set the POWER switch to ON (|) while pressing the REMOTE key.
The REMOTE key must be kept held down for more than two seconds after the power is turned ON.
The mode will switch and the instrument will start up.
CA-200 mode → CA-100 compatible mode
Display
REMOTE
CA-100 MODE
CA-100 mode → CA-200 compatible mode
Display
REMOTE
CA-200 MODE
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
x
y
Lv
x
y
Lv
POWER
ON
OFF
0
-CAL
1
15
15
When 4-digit display is set
When 3-digit display is set
MODE
REMOTE
HOLD
MR
MEM
Advertisement
Table of Contents
