Table of Contents
Advertisement
Changing Method for parameters 4 4 4 4 4 to A A A A A
For parameters 4 to A, switch the LCD display section to the menu selec-
tion screen as explained below.
1
.
Press the
key.
The LCD display section will switch to the menu selection screen.
2
.
Press the
key until the desired screen is displayed.
Each time the
key is pressed, the screen will switch in the order
PROBE→SYNC→ID Name input→RANGE→Measurement Speed→
Number of Digits→Calibration Standard data→RS232C Baud
Rate→PROBE.
3
.
Press the
key to select the desired setting, and
press the
key to confirm the selection.
For the ID name and range, enter the desired settings using the ten-key,
ALPHA and alphabet keys, then press the
tings.
Changing Method for parameter BC
For the setting method, refer to the page given in the above table.
<About the REMOTE Key>
The REMOTE key should not be pressed unless you are going to commu-
nicate with the PC via RS-232C or USB.
• Pressing the REMOTE key sets the instrument in remote mode, enabling communica-
tion with the PC via RS-232C or USB.
(The REMOTE lamp will light up.) In remote mode, no keys other than the REMOTE
key are effective.
To cancel remote mode, press the REMOTE key again.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
key to confirm the set-
BC
BC
BC
BC
31
Menu selection screen
MENU : SELECT
PUSH SPACE KEY
PROBE selection screen
SELECT : PROBE
P1 35881112
SYNC selection screen
SELECT : SYNC.
EXT
ID name input screen
CH01 EXT
Ad P1
[
RANGE setting screen
RANGE x,y
Lv
(%) 10
10
Measurement speed selection screen
SELECT : M-SPD
AUTO
Number of display digits selection screen
SELECT : DISP.
4 FIGURES
Calibration standard selection screen
SELECT : STD-DT
6500K
RS-232C baud rate selection screen
SELECT : BAUD
38400 BPS
]
Advertisement
Table of Contents
