Instrument Status At Power-On - Minolta CA-100Plus Instruction Manual

"PROBE ERROR"
• Cause 1 : A measuring probe was connected or disconnected while
the POWER switch was ON.
• Action 1: Set the POWER switch to OFF first, connect necessary measuring probes, then set the POWER
switch to ON. (Before connecting/disconnecting the measuring probe, make sure that the
POWER switch is set to OFF.)

2. Instrument Status at Power-ON

The instrument has been set prior to factory shipment so that it will be set as follows when the POWER switch is
set to ON.
① Measurement mode
② Memory channel no.
③ Target color
④ PROBE
⑤ SYNC mode
⑥ ID name
⑦ Analog display range value
⑧ Measurement speed
⑨ Number of display digits
⑩ Calibration standard
⑪ RS232C baud rate
⑫ Calibration data (stored) in CH00 to CH99 Page 51
⑬ CA-200 mode/CA-100 compatible mode
<Changing the Instrument Status at Power-ON>
Change necessary parameters and press the
whistling sound when the settings are saved. The instrument will start with the new settings when the power is
turned ON next time. (The selected mode and memory channel etc. will be stored in the instrument's memory, and
they will remain effective even if the POWER switch is set to OFF.)
Changing Method for parameters ① and ②
① Measurement mode ........Press the MODE key.
② Memory channel .............Press the CH
Changing Method for parameter ③
③ Target color value ...........The current target color will be changed if you
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Page 40
Page 48
Page 65
Page 43
Page 36
Page 67
Page 69
Page 36
Page 42
Page 50
Page 85
Page 15
key for more than five seconds. A bleep will sound, followed by a
and
select a mode other than flicker and then enter a
target color, or select user calibration or enter
the RGB emission characteristic for analyzer
mode.
xyLv mode
CH00
x = 0.3127 y = 0.3293 Lv = 160.0 (cd/m
P1
EXT mode
Consists of Blank spaces only.
10% (all ranges)
AUTO
4 digits
6500K (D65) Minolta's standard data
38400bps
6500K (D65) Minolta's standard data
CA-100 compatible mode
* For details, refer to the pages given in the above table.
keys.
30
PROBE ERROR
2
)