Counting Method; 8-3-1Key In A Known Unit Value; Sample Counting - Jadever JCAII Manual

1. Press under normal weighing mode.
2. Use numeric key to input the low limit value. Eg. 0.1kg.
3. Press to save and return.
Enable/disable the Auto-tare function
1. Under normal weighing mode, press
(If not press
2. If you want to enable auto-tare function, press
If you want to disable auto-tare function, press
Note: the unit of normal weighing and tare setting are same.

8-3 Counting method

8-3-1Key in a known unit value

1. Use numeric key to input the unit weight value(eg.1.2g), then press key
2. Put the article on the pan, and the scale starts counting
Note: Symbol " " points at "UW" when entered unit weight is lower than 4/5 of scale division. Unit
weight is too small for ensuring accurate quantity calculations.

8-3-2 Sample counting

Note: Do tare or zero-point before doing the following steps
1. Put samples onto the weighing pan and input the quantity with the numeric key.
(eg. 0.300kg, 20pcs)
2. Press key
. (If not, press
)
. The unit weight is calculated
appears in the Total Count window.
)
or . appears in the Total Count window.
V03
JCAII 10