Others Menu - Epson EB-L1075U User Manual

List of Functions
Submenu
Address 1 Set- Set the destination email addresses for the notification email, and
ting/ Address 2 the notification content. You can register up to three
Setting/ Address destinations. You can enter up to 64 single-byte alphanumeric
characters. You can enter up to 32 characters on the
3 Setting
Configuration menu. When entering more than 32 characters,
use your Web browser to enter the text. ( " ( ) , : ; < > [ \ ] and spaces
cannot be used.)
s "Changing Settings Using a Web Browser (Epson Web
Control)" p.215
Set to On to monitor the projector using SNMP. To monitor the
SNMP
projector, you need to install the SNMP manager program on
your computer. SNMP should be managed by a network
administrator. The default value is Off.
Trap IP Address You can register up to two IP addresses for the SNMP trap
1/ Trap IP Ad- notification destination.
dress 2
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Community Set the community name of SNMP. You can enter up to 32 single-
Name byte alphanumeric characters. (Spaces and symbols cannot be
used.)
Set this to On to use the PJLink notification function.
PJLink Notifica-
tion
Enter the IP address of the computer to which you want to send
Notified IP Ad-
dress notifications of the projector's operating status using the PJLink
notification function.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Function

Others menu

Submenu
To strengthen security, communication between the projector
Secure HTTP
and computer in Epson Web Control is encrypted. When setting
security with Epson Web Control, we recommend setting this to
On.
Imports the Web server certificate used in Secure HTTP.
Web Server Cert.
For the priority gateway, select either Wired or Wireless.
Priority Gateway
AMX Device Dis- When you want to allow the projector to be detected by AMX
covery Device Discovery, set this to On. Set this to Off if you are not
connected to an environment controlled by a controller from
AMX or AMX Device Discovery.
Set this to On only when monitoring or controlling the projector
Crestron Con-
nected over the network using Crestron Connected
this to Off.
s "About Crestron Connected
Changes in projector settings take effect upon restarting.
When this is set to On, you cannot use the Message Broadcasting
feature in Epson Projector Management.
159
Function
®
. Otherwise, set
®
" p.228