Epson EB-L1075U User Manual page 163

List of Functions
Submenu
Light Source Cal- Make settings related to Light Source Calibration. When
ibration performing Light Source Calibration, the difference between the
white balance and the brightness level for the light source is
corrected. We recommend running this function periodically.
• Run Now: Starts Light Source Calibration.
This cannot be started in the following cases.
- Within 20 minutes of turning on the projector.
- If the surrounding temperature gets too high, and the
brightness has been automatically dimmed.
• Run Periodically: When this is set to On, Light Source
Calibration is performed every 100 hours of use. When Off is
selected to maintain the projected image that has been adjusted
using Multi-Projection, perform corrections using Run Now
or set the scheduling function to perform Light Source
Calibration periodically.
• Schedule Settings: Displays the schedule settings screen. Set
Light Source Calibration to run periodically.
• Last Run: Displays the last date and time Light Source
Calibration was performed.
You can reset all items in the Configuration menu to their default
Reset All Config
settings.
The following items are not reset to their defaults: Input Signal,
EDID, Memory, Content Playback, User's Logo, all items for
Network menus, Language, Date & Time, Panel Alignment,
Color Uniformity, Lens Calibration, Color Matching, Light
Source Info, and Operation Hours.
Reset All (Factory Resets all of the projector's settings. However, Date & Time,
Default) Operation Hours, Light Source Info, Password Protection
items and their passwords are not reset. You need to enter a
password to perform a reset. The default password is set to
"0000". Change this to your own desired password.
Function
163