Images Are Fuzzy, Out Of Focus, Or Distorted; Interference Or Distortion Appear In Images - Epson EB-L1075U User Manual

Problem Solving

Images are fuzzy, out of focus, or distorted

Check
Is the focus adjusted correctly?
Is the projector at the correct distance?
Has condensation formed on the lens?

Interference or distortion appear in images

Check
Are the cables connected correctly?
Is an extension cable being used?
Is the correct resolution selected?
(Only when projecting computer images)
Is the Sync./Tracking adjusted correctly?
(Only when projecting computer images)
Is the Resolution set to anything other than Auto?
(Only when projecting on a split screen)
Make sure that at least 20 minutes has passed after the projection starts, and press the [Focus] button on the remote
control to adjust the focus.
s "Correcting the Focus" p.38
Is it projecting outside of the recommended projection distance range?
Setup within the recommended range.
s "Screen Size and Projection Distance"
If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient temperature
changes occur, condensation may form on the surface of the lens, and this may cause the images to appear fuzzy. Set the
projector up in the room about one hour before it is used. If condensation forms on the lens, turn the projector off and
wait for the condensation to disappear.
Check that all the cables required for projection are securely connected.
s "Connecting Equipment" p.47
If an extension cable is used, electrical interference may affect the signals.
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.274
s Computer's documentation
Press the [Auto] button on the Remote Control or the [
adjustment. If the images are not adjusted correctly even after performing automatic adjustment, you can also make
adjustments from the Configuration menu.
s Signal - Tracking, Sync. p.142
The image may be collapsed if the Resolution on the Configuration menu and the resolution of the projected image are
not the same.
If the image is collapsed, set the Resolution to Auto.
s Signal - Resolution p.142
Remedy
p.234
Remedy
] button on the Control panel to perform automatic
193