Curved Surface - Epson EB-L1075U User Manual

Adjusting the Projected Images
a
If the [Esc] button is pressed for approximately two seconds,
the confirm default reset screen is displayed.
Select Yes to reset the result of Quick Corner corrections.
e
Use the [ ], [ ], [ ], and [ ] buttons to correct the position of
the corner.
When you press the [
allows you to select the area to be corrected is displayed.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
f
Repeat steps 4 and 5 as needed to adjust any remaining corners.
g
To complete the corrections, press the [Menu] button.
] button, the screen shown in step 4 that

Curved Surface

This allows you to correct distortion that occurs when projecting on a
curved surface, and adjust the amount of expansion and contraction.
Face the projector directly opposing the screen with the lens position
moved to the home position.
"Adjusting the Position of the Projected Image (Lens Shift Adjustment)"
s
p.34
a
• Project onto an arc surface with the same radius.
• If a large amount of adjustment is performed, the focus may not be
uniform even after making adjustments.
• If 4K Enhancement is enabled, a message is displayed. Select Yes to
disable 4K Enhancement. (EB-L1075U/EB-L1070U/EB-L1065U/EB-
L1060U/EB-L1050U only)
s Image - Image Enhancement - 4K Enhancement
Use the following to check the adjustment range for the image.
"Curved Surface" p.261
s
a
Press the [Menu] button while projecting.
b
Select Geometry Correction from Settings.
c
Select Curved Surface, and then press the [
67
p.140
] button.