Reflecting Saved Settings To Other Projectors - Epson EB-L1075U User Manual

Batch Setup

Reflecting saved settings to other projectors

a
Disconnect the power cord from the projector, and check that all
of the projector's indicators have turned off.
b
Connect the USB flash drive on which the settings are saved to the
projector's USB-A port (the wireless LAN module installation
section).
a
• When the USB flash drive contains 1 to 3 types of batch
setup files, the file is reflected to the projector with the same
model number. If there are multiple files for a projector with
the same model number, the settings may not be reflected
correctly.
• When there are four or more types of batch setup files on the
USB flash drive, the settings may not be reflected correctly.
• Do not store any data except for the batch setup file on the
USB flash drive. If the USB flash drive contains data other
than the batch setup file, the settings may not be reflected
correctly.
c
While holding down the [Menu] on the remote control or the
control panel, connect the power cord to the projector.
When the projector's indicators turn on as follows, release
the [Menu] button.
Power supply Status
Blue - On Blue - On
The indicators remain on for about 75 seconds.
When all of the indicators start flashing, the settings are being
written.
Laser Temp
Orange - On Orange - On
167