Notifications Menu - Epson EB-L1075U User Manual

List of Functions
Submenu
IP Address Dis- To prevent the IP address from being displayed on the LAN
play Standby screen, set this to Off.
Perform settings to use the IPv6 protocols.
IPv6 Settings
a
IPv6: Set this to On when using IPv6 protocols. Make sure one
link local address is set when using IPv6. This is composed of the
interface ID created from fe80:: and the projector's MAC address.
Auto Configuration: Set this to On to automatically acquire an
IPv6 address from RA (Router Advertisement). The address is
composed as shown below.
• Stateless Address (0 to 6): Created automatically by combining
the prefix acquired from the RA (Router Advertisement) and
the interface ID created from the projector's MAC address.
• Stateful Address (0 to 1): Created automatically from the
DHCP server using DHCPv6.
Use Temporary Address: Set this to On to temporarily validate
the IPv6 address (0 to 1) when Auto Configuration is On.

Notifications menu

When this is set, you receive an email notification if a problem or warning
occurs in the projector.
Function
• The following functions support IPv6 proto‐
cols.
- Epson Web Control
- PJLink
• When setting the IPv6 address manually,
make settings in Advanced from Epson Web
Control.
s "Changing Settings Using a Web Browser
(Epson Web Control)" p.215
"Reading error notification mail"
s
Submenu
Set to On to send an email to the preset addresses when a problem
Mail Notification
or warning occurs with a projector.
You can input the IP Address for the SMTP server for the
SMTP Server
projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Port Number You can input the port number for the SMTP server. The default
value is 25. You can input numbers between 1 to 65535.
Enter the email address of the sender. You can enter up to 64
From
single-byte alphanumeric characters. You can enter up to 32
characters on the Configuration menu. When entering more
than 32 characters, use your Web browser to enter the text.
( " ( ) , : ; < > [ \ ] and spaces cannot be used.)
s "Changing Settings Using a Web Browser (Epson Web
Control)" p.215
158
p.225
Function