Installing The Projector; Removing And Attaching The Projector Lens Unit; Attaching - Epson EB-L1075U User Manual

Installing the Projector

Removing and Attaching the Projector Lens Unit

Warning
Make sure you disconnect the power cord from the projector before removing
or attaching the lens unit to the projector. Otherwise, it could cause an electric
shock.

Attaching

Attention
• Do not attach the lens unit when the projector's lens insertion section is
facing up. Dust or dirt could enter the projector.
• Try not to touch the lens section with your hand or fingers. If fingerprints or
oils are left on the surface of the lens, projection quality deteriorates.
a
• The projector supports lens with the following model numbers.
ELPLX01, ELPLX01W, ELPLU03, ELPLU04, ELPLW05, ELPLW06,
ELPLW08, ELPLM08, ELPLM09, ELPLM10, ELPLM11, ELPLM15,
ELPLL08, ELPLS04, ELPLU02, ELPLR04, ELPLW04, ELPLM06,
ELPLM07, ELPLL07
When using the following lens, set the Lens Type in the
Configuration menu according to the lens you are using so that
distortion correction is performed correctly.
ELPLS04, ELPLU02, ELPLR04, ELPLW04, ELPLM06, ELPLM07,
ELPLL07
s Extended - Operation - Advanced - Lens Type
• In a normal installation, the image may be tilted depending on your
lens. Adjust the tilt of the image using the front and rear feet.
s "Adjusting the Horizontal Tilt (for Normal Installment)"
p.42
• For information on installing ELPLX01/ELPLX01W, see the User's
Guide supplied with ELPLX01/ELPLX01W.
a
Pull the lens replacement cover straight out.
b
Release the lock lever if it is locked.
27
p.146