Checking The Projector Id; Setting The Remote Control Id - Epson EB-L1075U User Manual

Installing the Projector
e
Select Set, and then press the [
f
Press the [Menu] button to close the Configuration menu.

Checking the projector ID

During projection, press the [
button.
Remote control
When you press the buttons, the current Projector ID is displayed on the
projection screen. It disappears in about three seconds.
] button.
] button while holding down the [ID]

Setting the remote control ID

a
Set the remote control [ID] switch to On.
b
While holding the [ID] button, press a number button to select a
number to match the ID of the projector you want to operate.
"Checking the projector ID"
s
Enter a two digit number (Example: 01 when the ID is 1).
Remote control
Once this setting has been made, the projector that can be operated by the
remote control is limited.
a
The remote control ID setting is saved in the remote control. Even if
the remote control batteries are removed to replace them and so on,
the stored ID setting is retained. However, if the batteries are left out
for a long time, it is reset to the default value (ID0).
43
p.43