Projector Network Settings - Network Menu
Setting
Options
From
Up to 32
alphanumeric
Address 1 Setting
characters
Address 2 Setting
Up to 64
Address 3 Setting
alphanumeric
characters from the
Web browser
(do not use " ( ) , : ;
< > [ \] spaces)
SNMP
On
Off
Trap IP Address 1
IP address
Trap IP Address 2
Community Name
Up to 32
alphanumeric
characters
(do not use spaces
and any symbols
other than @)
PJLink Notification On
Off
Description
Enter the email address of the sender.
Enter the e-mail address, and select the
alerts you want to receive. Repeat for up
to 3 addresses.
Set to On to monitor the projector using
SNMP. To monitor the projector, you
need to install the SNMP manager
program on your computer. SNMP
should be managed by a network
administrator.
The default value is Off.
Enter up to two IP addresses to receive
SNMP notifications, using 0 to 255 for
each address field.
Do not use these addresses: 127.x.x.x or
224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255).
Set the SNMP community name.
Enables or disables the PJLink
notification function.
Setting
Options
Notified IP Address IP address
Network Menu - Others Menu
Settings on the Others menu let you select other network settings.
Network > Network Configuration > Others
s
Setting
Options
Secure HTTP *
On
Off
157
Description
Enter the IP address to receive the
projector's operating status when the
PJLink notification function is enabled.
Enter the addresses using 0 to 255 for
each address field.
Do not use these addresses: 127.x.x.x or
224.0.0.0 through 255.255.255.255
(where x is a number from 0 to 255).
Description
To strengthen security, communication
between the projector and computer in
Web control is encrypted. When setting
security with Web control, it is
recommended to set this to On.