Management Using Snmp; Esc/Vp21 Commands; Command List; Cable Layouts - Epson EB-L1075U User Manual

Monitoring and Controlling

Management Using SNMP

By setting SNMP to On in the Configuration menu, notification messages
are sent to the specified computer when a problem or warning occurs. This
allows you to check for problems with projectors even at locations away
from the projectors.
Network - Notifications - SNMP
s
a
• SNMP should be managed by a network administrator or someone
who is familiar with the network.
• To use the SNMP function to monitor the projector, you need to
install the SNMP manager program on your computer.
• The SNMP Agent for this projector complies with version 1
(SNMPv1).
• The managing function using SNMP cannot be used over wireless
LAN in Quick connection mode.
• Up to two destination IP addresses can be saved.

ESC/VP21 Commands

You can control the projector from an external device using ESC/VP21.

Command list

When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error message is
output and a ":" is returned.
p.158
The main contents are listed below.
Item
On
Power ON/OFF
Off
Signal selection Computer
BNC
HDMI
USB
LAN
DVI-D
HDBaseT
On
A/V Mute On/Off
Off
Add a Carriage Return (CR) code (0Dh) to the end of each command and
transmit.
For more details, contact your local dealer or the nearest address provided
in the Epson Projector Contact List.
Epson Projector Contact List
s

Cable layouts

Serial connection
• Connector shape: D-Sub 9-pin (male)
226
Command
PWR ON
PWR OFF
Auto SOURCE 1F
RGB SOURCE 11
Component SOURCE 14
Auto SOURCE BF
RGB SOURCE B1
Component SOURCE B4
SOURCE 30
SOURCE 52
SOURCE 53
SOURCE A0
SOURCE 80
MUTE ON
MUTE OFF