INSTALLING THE RESTRAINT INTO THE CAR
(USING ISOFLEX CONNECTORS IF SUPPLIED WITH THE CHILD RESTRAINT)
To prevent damage to vehicle seat it may be necessary to remove or open a trim covering the ISOFIX low
anchorages.
A. Locate the ISOFIX Low
Anchorages in the vehicle
rear seat. If you cannot locate
the ISOFIX bars, check your
vehicle owners manual.
B. With the restraint upright, remove both ISOFLEX
connectors from storage on the upper sides of
the restraint by pressing the red release button
on the connector.
C. Recline instructions are shown on page 57.
D. Press and hold the ISOFLEX strap adjuster
button and pull the connector strap to fully
lengthen. Repeat for both connector straps.
62
Instructions for Installation & Use
The location may be
identified by one of the
following symbols.
ISOFIX low anchors in the
vehicle rear seat
Storage Pin
Push button and lengthen