Download Print this page

Britax safe-n-sound BS0072E-i20133 Instructions For Installation & Use page 27

Convertible car seat with optional isofix compatibility uitable for birth to 4 years (approx)
Hide thumbs Also See for safe-n-sound BS0072E-i20133:

Advertisement

Continue to use this child restraint in the rear facing mode until the child's shoulders reach the limit of
the lower or middle shoulder height marker before turning the seat to face forward. A younger child's
neck muscles may be unable to support their head thus the child should remain rear facing until the neck
muscles can hold the head steady.
To ensure that the space is sufficient the purchaser should check the
measurement between the seat back of the rear seat and all front
seats in the car in which the child restraint is intended to be used. The
length may be longer when the headrest is raised in rear facing mode.
Regional Road Rules may prohibit the use of this restraint in the front
seat until the child is 4 years of age. Check your Regional Road Rules
for exemptions.
DO NOT USE RESTRAINT IN REARWARD FACING MODE
WITHOUT STABILISING BAR FULLY EXTENDED.
Do not use the restraint without the top tether strap correctly attached
to the vehicle anchorage.
DO NOT USE A REAR FACING CHILD RESTRAINT WHERE AN
AIRBAG IS FITTED IN FRONT OF THE SEATING POSITION.
If an airbag is fitted in the desired seating position where the child
restraint is fitted, follow the vehicle manufacturer's warnings and
instructions. Do not use on any vehicle seat which faces sideways or
rearwards.
Never leave babies or toddlers in a stationary car in the sun because of the risk of heat exhaustion.
Ensure babies and toddlers have adequate ventilation and are shaded from direct sunlight through side or
rear windows.
CHILD RESTRAINT UPPER ANCHORAGE FITTING
To use this child restraint, the car will need a child restraint upper anchorage fitting in the seating position
that you intend to use. Refer to the car owner's handbook.
The upper anchorage fitting is required for attaching the top tether in both rear facing mode and forward
facing mode covered later in the these instructions.
If no upper anchorage fitting is provided then you will need to install an upper anchorage fitting. Refer to
pages 85 to 88.
435mm
570mm
Seat Width 440mm
Do not allow the front seat to alter
the installed angle of the restraint.
It is permissible to allow the
restraint to touch the front vehicle
seat.
Instructions for Installation & Use
27

Advertisement

loading

This manual is also suitable for:

Safe-n-sound bs0072e-020133