Britax safe-n-sound BS0072E-i20133 Instructions For Installation & Use page 50

E. To convert the restraint from Rearward Facing mode to
Forward Facing mode, Pull the stabilising bar upward
and away from the seat to unlock and rotate.
F. Rotate the stabilising bar around so that it is in position
at the bottom rear of the seat. Either recline or upright
position may be set by locking into the forward or
rearward slot.
G. Disengage seatbelt tongue from buckle and remove
the seatbelt from the restraint belt paths. Allow seatbelt
to feed back into seatbelt retractor.
DISCONNECT TOP TETHER AND ISOFLEX
CONNECTORS
To store the ISOFLEX connectors on the inside of the
seat wings.
A. Press the ISOFLEX strap adjuster button to release
tension on the straps.
B. Press each of the red release buttons on the
ISOFLEX connectors and remove them from the
vehicle ISOFIX low anchorages.
C. Fully lengthen the ISOFLEX strap and engage each
ISOFLEX connector onto its storage pin.
Remove slack but do not tighten. The storage pin
may be damaged if the strap is tightened.
50
Instructions for Installation & Use
Pull out to
unlock
Rotate
stabilising bar
Storage Pin