Britax safe-n-sound BS0072E-i20133 Instructions For Installation & Use page 28

PREPARING FOR INSTALLING INTO VEHICLE - REARWARD FACING
The restraint is normally packaged in the fully upright
forward facing mode. If you need to use it rearward facing
you must first fully convert the restraint to rearward facing
mode as shown below.
If upper anchorage strap is folded up for storage undo
storage strap and lengthen. Fully press adjuster button (1)
while pulling upper anchorage strap (2) to lengthen.
CONVERT TO REARWARD FACING MODE
A. Push the stabilising bar downward to unlock it from the
seat.
B. Rotate the stabilising bar around so that it is in position at
the front of the seat.
C. While in position, push down on the stabilising bar to lock
into position as shown.
IMPORTANT:
DO NOT USE RESTRAINT IN REARWARD FACING MODE
WITHOUT THE STABILISING BAR LOCKED IN POSITION.
28
Instructions for Installation & Use
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
Pushdown
to unlock.
Push to lock
2
Rotate
stabilising
bar