Britax safe-n-sound BS0072E-i20133 Instructions For Installation & Use page 45

PLACING CHILD INTO RESTRAINT (REARWARD FACING)
A. Check that the harness shoulder straps are in
the correct position. Refer to pages 43 for correct
shoulder harness strap height and for setting up the
harness.
B. Slacken the top tether strap if not already slack and
allow the straps to fall to the sides of the restraint for
easier access to the child.
C. Loosen shoulder straps by pushing in the harness
adjuster and pulling both shoulder straps evenly.
Pull out the desired amount of slack.
D. Store buckle tongues on the buckle tongue holders
while placing baby in the child restraint.
E. Place baby into child restraint lying on its back so
that the buckle is between the baby's legs. Ensure
that baby's arms and legs are free. Make sure baby
is dressed to allow the Harness Buckle to be pulled
up between baby's legs e.g. a jump suit.
NOTE: The headrest should be adjusted so that
shoulder strap slots and headrest wings are just
above the shoulders, not below the shoulders.
CAUTION:
Do not harness an infant wrapped in a blanket or swaddled as this increases the risk of ejection and
injury or death in a crash. The harness needs to fit firmly to the baby, any blanket or other covering may
be placed over the harness after the harness is adjusted. Arms and legs must be free and not bound or
wrapped together. The legs must sit on each side of the crotch strap.
IMPORTANT :
Always adjust the height of the headrest thus the shoulder straps as the child grows.
Pull Straps
Buckle tongue
holder on both
sides of the
seat. Push
tongue inwards
to engage.
Instructions for Installation & Use
Push in
to adjust
harness
45