Britax safe-n-sound BS0072E-i20133 Instructions For Installation & Use page 64

I. If upper anchorage strap is folded up for storage undo
storage strap then lengthen. Fully press adjuster button
(1) while pulling upper anchorage strap (2) to lengthen.
J. Fit the attachment clip on the upper anchorage strap to the
anchor fitting as shown. Make sure to remove as many twists
as possible from the upper anchorage strap.
Always attach the hook and remove slack
K. Tighten adjustable top tether strap by pulling adjustment
strap to remove slack as shown below, but do not over-
tighten causing the restraint base to lift off the vehicle
seat.
L. Fold up excess strap and use the top tether pocket to
store excess strap away from child's reach.
IMPORTANT :
Always secure the loose end of the top tether strap to
prevent it hanging out of the car or being accessible by
the child.
THIS RESTRAINT IS NOT SUITABLE FOR USE WHERE
THE TOP TETHER STRAP MAY FALL INTO A SPLIT IN
THE SEAT BACK OR OFF THE SIDE OF THE SEAT.
Always ensure that the car seatbelt is firmly restraining the
restraint on the vehicle seat.
ALWAYS ATTACH TOP TETHER HOOK AND REMOVE
SLACK IN THE TOP TETHER STRAP.
A LOOSE TOP TETHER IS DANGEROUS.
Check that the seatbelt is not twisted and the diagonal
belt is only clamped by the lock-off which is located on the
opposite side from the car seat buckle.
64
Instructions for Installation & Use
Fully press Adjuster Button (1) while
pulling Upper Anchorage Strap (2) to
lengthen.
1
Attachment Clip
Attach
Car's Anchor Fitting
Pull Adjustment Strap to remove slack
Roll up excess
strap and store
in the pocket
attached to the
cover.
2